Maintenance Schedule - probst SH-2500-UNI-GL Operating Instructions Manual

Maintenance
• The inspector cannot attach the inspection label unless the inspection has been performed successfully.

9.3 Maintenance schedule

Probst stipulates the following checks and check intervals. The operator must comply with the legal regula-
tions and safety regulations applicable at the location of use. These intervals apply to single-shift operation.
For heavier use, such as multi-shift operation, the intervals must be shortened accordingly.
 Check and tighten all fastening screws after 25 hours of operation.
Regularly check every 50 h of operation:
1. Check all fastening screws and tighten with the valid tightening torque.
2. Check that all joints, guides, bolts and gear wheels are working properly. Adjust or replace as needed.
Maintenance task
Check the condition of load securing chain
and the suspension hook.
Check safety features:
• Gauge
• Warning device
Check and clean the sealing lips of the suction
plates, replace if worn.
Clean all dust filters, replace if necessary.
Drain the condensation water.
Check the vacuum circuit for leaks.
Check the condition of the hose connections.
Check all load-bearing parts (e.g. suspension)
for deformation, wear or other damage.
Check the legibility of the type and lift capaci-
ty plates. Clean if necessary.
Check the legibility of the warning signs.
Clean if necessary.
Is the test label up to date?
Check the general condition of the lifting de-
vice.
The operating instructions are available, legi-
48 / 58
Daily Weekly
X
X
X
X
X
Monthly Every six
months
X
X
52400046 / 52400048
Yearly
X
X
X
X
X
X
X
X
X
X
X
X
X