File Transmission; Features; File Transmission Procedure - Renesas R9A06G037 User Manual

PRIME v1.4 Base Node Tool
User Manual
3.8

File transmission

3.8.1

Features

-
Any single file is available for transmission.
-
File Transmission direction is both BN to SN and SN to BN.
-
File is copied in the same directory with the Demo Tool (destination side).
-
File transfer rate and Progress indicator is displayed during transmission.
-
Support File Transmission cancel.
3.8.2

File Transmission procedure

(1) Start the BN tool (prime14_cpx3_pc_bn_RevXXX.exe) and the Renesas PRIMEv1.4 Service Node
tool (UpperMAC_RevX.X.X.X.exe) (Please refer to this tool manual to operation). It is necessary for
both Tool to be started without depending on the transmission direction. (If sending device is BN
and receiving device is SN, SN tool creates a file from transferred data.)
(2) Wait until SN is registered to the network.
(3) Using "prime14_cpx3_pc_bn_RevXXX.exe", Select destination device (SN) for file transmission.
(Multiple devices are selectable.)
R11UM0156EJ0240 Rev.2.40
Jul. 28, 2020
Figure 3.30 Select a destination device and modulation
Renesas Electronics Group Confidential
.
3 PC Tool operation procedure
PRELIMINARY
Notice This is not a final specification. Some
parametric limits are Subject to change.
Page 42 of 82