Precautions For Serial I/O (Clock-Synchronous Serial I/O); Transmission/Reception - Renesas M16C/26 Series Reference Book

Under development
Preliminary specification
Specifications in this manual are tentative and subject to change.
M16C/26 Group

1.6 Precautions for Serial I/O (Clock-synchronous Serial I/O)

1.6.1 Transmission/reception

1. With an external clock selected, and choosing the RTS function, the output level of the RTSi pin goes
to "L" when the data-receivable status becomes ready, which informs the transmission side that the
reception has become ready. The output level of the RTSi pin goes to "H" when reception starts. So if
________
the RTSi pin is connected to the CTSi pin on the transmission side, the circuit can transmission and
reception data with consistent timing. With the internal clock, the RTS function has no effect.
2. If a low-level signal is applied to the P8
phase output forcible cutoff by input on SD pin enabled), the RTS
ance state.
Rev.0.90 2003.12.28 page 15 of 28
1.6 Precautions for Serial I/O (Clock-synchronous Serial I/O)
_______
________
________
_______ _____
/NMI/SD pin when the TB2SC register IVPCR1 bit = "1" (three-
5
_____
_______
_________
and CLK pins go to a high-imped-
2 2
________