Table of Contents
Advertisement
PRIME v1.4 Base Node Tool
User Manual
3.6.4
Getting Statistics Information
BN tool outputs the statistics information about peer communication quality both SN and BN itself
stored while it executes AppEmu cycle test. In order to enable this function, user needs to check "Get SN
Information" in AppEmu setting dialog.
3.6.4.1
SN Statistics Information with AppEmu Cycle Test Result
BN tool collects the SN statistics information by additional data communication on the MGMT
connection during the AppEmu cycle test.
It outputs the log file "%Y%m%d%H%M%S_prime14_cpx3_pc_bn_sn_statistics.log" contains
following information.
- Result of AppEmu test for each cycle.
- Number of times for each modulation of the transmitted Data packet.
- Number of times for each SNR of the received Data packet.
- Number of times it was reset.
- Number of times for each modulation of the transmitted REG_REQ packet.
- Information of the beacon SN detected until it completes the registration process.
Details of the contents described in the log are described follow.
- Cycle_No shows the cycle number of the test.
- Node_No shows the number (starts from 0000) of the destination SN.
- SID shows the SID of the destination SN.
- LNID shows the LNID of the destination SN.
- SERIAL shows the serial number of the connection.
- DataSize[bytes] shows the size of transmitting packet.
- CycleTime[100ms] shows the time of each cycle.
- Success shows the total number of successful times for each step.
- Failed shows the total number of failures for each step.
- Retransmittion shows the total number of re-transmission of each cycle.
- U_DBPSKR shows the number of the transmitted Data packet via uplink using DBPSK-R. Similarly,
U_XXX show the number of transmitted Data packet via uplink using each modulation. ("XXX" is
each modulation.) This value is the sum of Data packet number transmitted by all subordinate
nodes.
- D_DBPSKR shows the number of the transmitted Data packet via downlink using DBPSK-R.
Similarly, D_XXX show the number of transmitted Data packet via downlink using each modulation.
("XXX" is each modulation.)
- D_SNR[0..7] shows the number of the received Data packet via downlink for each SNR value of
PHY_SNR.
- U_SNR[0..7] shows the number of the received Data packet via uplink for each SNR value of
PHY_SNR. This value is the sum of the Data packet number transmitted by all subordinate nodes.
- RESET shows the number it was reset.
- REG_REQ_DBR shows the number of the transmitted REG_REQ packet using DBPSK-R. Similarly,
REG_REQ_XXX show the number of transmitted REG_REQ packet using each modulation. ("XXX"
is each modulation.)
- BCN[0..7]_SID shows the SID of the received beacon.
- BCN[0..7]_Level shows the hierarchy level of the received beacon.
- BCN[0..7]_RxLevel shows the intensity of the received beacon.
- BCN[0..7]_MOD shows the modulation of the received beacon.
- BCN[0..7]_RawSNR shows the raw SNR in dB of the received beacon.
R11UM0156EJ0240 Rev.2.40
Jul. 28, 2020
Renesas Electronics Group Confidential
.
3
PC Tool operation procedure
PRELIMINARY
Notice This is not a final specification. Some
parametric limits are Subject to change.
Page 35 of 82
Advertisement
Table of Contents
