Protecting The System - Leica TCS SP8 STED 3X User Manual

Additional Notes on Handling the System
• Do not switch the workstation off after a software crash, but restart the LAS X software
after 15 seconds. No image data are lost in case of a software crash. If the LAS X
software is restarted without restarting the workstation, the data is automatically
restored. If the software crash is caused by a crash of the workstation, the image data
will be lost.
6.3

Protecting the system

• Observe the maintenance instructions and intervals prescribed in the Chapter
"Maintenance".
• During the update of the firmware, a continuous warning signal sounds. The audible
warning signal stops after the updated component is automatically restarted. During the
automatic update and the automatic restart of the component, you may not switch off or
restart the system, since otherwise this can lead to damage to the system.
• Protect the system from dust and grease.
• Make sure to use only one small drop of immersion fluid. The immersion fluid may not
contaminate or enter the microscope.
• Make sure that the specimen carrier is not against the objective and cannot be damaged
by it or cause broken glass.
• Be absolutely certain to prevent the optics and mechanical parts from coming into direct
contact with acids, bases and other aggressive chemicals.
• Never use abrasive products to clean the system and its components. Abrasives can
scratch the surface and thus have a negative effect on the protection of the parts.
• Protect the microscope from excessive temperature fluctuations. Such fluctuations can
lead to the accumulation of condensation, which can damage the electrical and optical
components.
• Allow the entire system to cool down to room temperature before covering the system
with a dust cover. This prevents condensation from forming below it, which can enter the
system and damage it.
• When used as intended, the HyD reflected light detectors are sufficiently protected from
destruction due to overexposure by measures in LAS X and by an electronic protective
circuit. An audible signal (beep) warns the user if the detector is being operated near the
maximum permitted signal level. If the maximum permitted signal level is exceeded, the
detector automatically switches off and the red status LED on the detector module lights
up.
• If you have any further questions, please directly contact the Leica branch office in your
country (see Chapter "Contact").
22