To Install for PRI QSIG
To install and configure the PRI Card in the DSU as a
PRI/QSIG variant, see "Installing 3300 Network Service
Units" on page 29, and follow the steps for installing as a
PRI/QSIG variant.
These are the steps that are required for installation and
programming:
1. Connect a computer to the PRI card.
2. Install a Direct Connection Device Driver on a
computer.
3. Create a Dial-up Network connection on your
computer.
4. Connect the computer to the PRI Card.
5. Use the IMAT Tool to complete required PRI
configuration.
6. Connect the PRI Card to the ISDN network.
Install the Peripheral Resource Card
Each FIM in the DSU must have a Peripheral Resource
Card (PRC) installed above it.
WARNING: Power must not be applied to the
Peripheral Unit while you are installing the Peripheral
Resource card.
To install a PRC in a DSU:
1. Unpack the PRC.
2. Slide the PRC into the top of slot 1 until it connects
firmly with the backplane.
3. Fasten the PRC in place using the two screws
provided, or use the latches on the card guides.
Installation
75