Installing Peripheral Units; Overview; Unpack, Position, And Ground The Peripheral Unit - Mitel 3300 Technician's Handbook

Technician's Handbook

Installing Peripheral Units

Overview

1. Unpack, position, and ground the Peripheral Unit

2. Connect the fiber cable to the node (page 49).
3. Install the power converter (page 50).
4. Install the Peripheral Interface cards (page 51).
5. Cable the node to the MDF (page 52).
6. Program the Peripheral Unit (page 59).
Next: Install any other required Service Unit (see
"Overview" on page 29). If all the Service Units are
installed, go to "Installing Phones and Peripherals" on
page 80.
Unpack, position, and ground the Peripheral Unit
WARNING:Do not apply power to the Peripheral Unit
until the ground cable is installed.
1. Remove the peripheral node from its packaging.
2. Check the contents against the packing list.
3. Visually inspect the node and attached equipment for
4. Position the node.
48
(page 48).
Note: For information about removing and replacing the
front panel of the cabinet, see "Remove/Install the Front
Panel" on page 117.
damage. Repack and return any damaged
equipment.