Program The Peripheral Unit; Table 22. Peripheral Unit Programming Settings - Mitel 3300 Technician's Handbook

Program the Peripheral Unit

1. Power up the Peripheral Unit.
Note: The unit will be in an abnormal operation mode until
all the programming is complete.
2. Using ESM, program the Peripheral Unit settings on
the Controller.
a. Program the forms in the Peripheral/DSU Unit
folder (System Configuration section,
Units/Modules folder). See Table 22 below and
the Online Help for more information.
Note: See Appendix D on page 237 for the location of the
Controller Modules, ports and cabinets.
Table 22. Peripheral Unit Programming
Cabinet
Shelf
Slot
b. If required, program the applicable forms in the
Analog Trunks folder (System Configuration
section, Trunks folder). See the Online Help for
more information.
Next: Install any other required Service Unit (see
"Overview" on page 29). If all the Service Units are
installed, go to "Installing Phones and Peripherals" on
page 80.
Settings
n (starts at 6)
1
17
Installation
59