Installing The Applications Card - Mitel MIVOICE OFFICE 400 Installation Manual

Manufacturer:
Mitel South Pacific Pty Ltd ("Mitel")
Level 1, 219 Castlereagh Street
Sydney, NSW2000, Australia
Phone: +61 2 9023 9500

Installing the applications card

Installation and commissioning of the applications card with the pre-in-
stalled applications.
Installing the applications card
The applications card can only be fitted to slot 2. This is located at the bottom
left, below slot 1 with the CPU1 processor card for the communication server.
To fit the applications card into the communication server, proceed as follows:
1. Create a backup of the configuration data on the communication server if
the server is already in service or has already been configured.
2. Check the communication server IP environment with regard to the follow-
ing:
Note:
There should be no other communication server with installed
applications card on the communication server subnet.
3. Make sure that the communication server is deactivated.
4. Unscrew the screw on the larger dummy cover in slot 2 and remove the
cover by pulling the screw.
5. Remove the plastic cover of the narrow dummy cover in slot 2. To do so in-
sert a screwdriver at an angle from below to release the snap-in mecha-
nism on the plastic cover.
6. Unscrew the screw on the narrow dummy cover and remove the cover by
pulling the screw.
7. Carefully slide the applications card into the shaft of slot 2 and gently press
the card as far as it goes into the connection on the backplane.
8. Use the screw to secure the card in its slot.
The applications card is now installed.
Applications Card CPU2-S
syd-0620/1.1 – R4.0 – 01.2016
Installing the applications card
Note:
Repairs to this product may be made only by the manufacturer
and its authorized agents, or by others who are legally author-
ized. Unauthorized repair will void this express warranty.
13