Mitel 3300 Technician's Handbook page 95

R2 Card Installation Overview
Install the R2 card in the following sequence:
1. In ESM, program the customer data in the 3300 ICP.
2. Configure the card for Line Side or Trunk Side
termination (see below).
3. Install the interface assembly (see "Install the
interface assembly on cards" on page 66).
4. Install the R2 card ("Install a DSU card" on page 65).
5. Configure the IMAT database (see below).
6. Connect the computer to the R2 card (see "IMAT" on
page 35).
7. Save the IMAT database onto the R2 card.
8. Connect the R2 Card to the PSTN network (see
page 78 below).
Next: Go back to "Install a DSU card" on page 65".
To configure the R2 card for Line Side or Trunk side
termination:
1. Attach the anti-static strap to your wrist.
2. Unpack the R2 card and inspect it to ensure that it is
not damaged.
3. Ensure the jumper block covers the NT position for
the Trunk Side termination and the LT position for
Line Side termination.
4. Set the termination impedance switch of the line to
the up position for 120 ohms or down for 75 ohms.
Installation
77