CEStronics CES OMEGA FLEX Assembly And Operating Manual page 15

5.2.1 Activating office mode
Required:
Locking medium that is authorised for the office function
l
Locking device with office function
l
Procedure:
Steps
1. Hold a locking medium authorised for the office function in the reading field of the
locking device.
The locking medium is read and accepted.
2. Continue to hold the locking medium in the reading field of the locking device (for approx.
2 seconds).
Office mode is activated.
Office mode is now active. The door can now be opened without locking media until the end
of office hours. LINE locking devices automatically disengage again at the end time set in
OMEGA Client.
In V-NET there is no end time when the locking device automatically disengages. Therefore, office mode on V-NET
locking devices must be deactivated using an authorised locking medium.
Troubleshooting:
Problem Cause
No signal after approx. 2 No office function has been set up for
seconds. Office mode is this locking device.
not activated. The
The office function is not currently
locking device engages,
available.
but then disengages
This locking medium is not authorised
again at the end of the
for the office function.
opening duration.
Wide shield replacement handle set ILS-I
5.2 Details about the office function
Signal
1x short green
1x short
1x long green
Solution
Have the office function set up for the locking device by
the system administrator.
Ask the system administrator when the office function can
be activated in this locking device.
Have the locking medium authorised for the office
function by the system administrator.
green,
Page 15 of 83