Table of Contents
Advertisement
This document may be translated into other languages for convenience, and you agree that if there is any conflict between the
English version of this document and any translation, the terms of the English version of the Agreement shall prevail.
Words and logos marked with
elsewhere. All rights reserved. Other brands and names mentioned in this document may be the trademarks of their respective
owners. Please follow ARM's trademark usage guidelines at
Copyright © 2010–2012, 2015–2017, ARM Limited or its affiliates. All rights reserved.
ARM Limited. Company 02557590 registered in England.
110 Fulbourn Road, Cambridge, England CB1 9NJ.
LES-PRE-20349
Confidentiality Status
This document is Non-Confidential. The right to use, copy and disclose this document may be subject to license restrictions in
accordance with the terms of the agreement entered into by ARM and the party that ARM delivered this document to.
Unrestricted Access is an ARM internal classification.
Product Status
The information in this document is Final, that is for a developed product.
Web Address
http://www.arm.com
Conformance Notices
This section contains conformance notices.
Federal Communications Commission Notice
This device is test equipment and consequently is exempt from part 15 of the FCC Rules under section 15.103 (c).
Class A
Important: This is a Class A device. In residential areas, this device may cause radio interference. The user should take the
necessary precautions, if appropriate.
CE Declaration of Conformity
The system should be powered down when not in use.
It is recommended that ESD precautions be taken when handling DSTREAM equipment.
The DSTREAM modules generate, use, and can radiate radio frequency energy and may cause harmful interference to radio
communications. There is no guarantee that interference will not occur in a particular installation. If this equipment causes harmful
interference to radio reception, which can be determined by turning the equipment off or on, you are encouraged to try to correct
the interference by one or more of the following measures:
•
Ensure attached cables do not lie across the target board.
•
Increase the distance between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult ARM Support for help.
It is recommended that wherever possible shielded interface cables be used.
ARM 100956_0527_00_en
®
or ™ are registered trademarks or trademarks of ARM Limited or its affiliates in the EU and/or
Note
Copyright © 2010–2012, 2015–2017 ARM Limited or its affiliates. All rights reserved.
http://www.arm.com/about/trademark-usage-guidelines.php
Non-Confidential
ARM
DS-5
®
3
Advertisement
Table of Contents
