4 Monitoring NBP
Select
2
Up to four measurement phases can be setup which will run consecutively. For each phase you can
set the number of measurements and the interval between them. If you want to run less than four
phases in a sequence, you can set the number of measurements for one or more phases to
3
Select each phase in turn (A, B, C and D) and select the number of measurements and the time
interval between the measurements.
To have measurements continue after the sequence, set the number of measurements for your last
4
phase to
CAUTION
Be aware that, if none of the phases are set to
measurement of the last phase.
When the NBP measurement mode is set to
changed.
Understanding the NBP Numerics and Symbols
Note: The Alarms Off symbols indicate that no physiological alarms are available from the Cableless
Measurement Devices when not assigned to a host.
Measurement modes with a series of measurements can be indicated with two different symbols:
indicates that a series is running and
shows the relative time to the next
measurement.
An S in front of the symbol indicates
the sequence is currently running.
During Measurements
The cuff pressure is displayed instead of the timestamp.
44
Setup Sequence
to open the
Cont
and this phase will run indefinitely.
Setup Sequence
menu.
Cont
, NBP monitoring will end after the last
Sequence
, the repetition time for
Systolic/Diastolic pressure
1
Mean pressure
2
Pulse rate
3
4
Pulse rate indicator
Measurement mode (see below)
5
Alarms Off symbol for Pulse
6
Timestamp
7
Alarms Off symbol for NBP
8
indicates that auto or sequence mode is
selected but the measurement series has
not yet started.
Sequence
mode and an A, B, C or D indicates which phase of
Off
.
Auto
mode cannot be
Need help?
Do you have a question about the IntelliVue CL SpO2 and is the answer not in the manual?