Controls Available With A Patient Monitor - Philips IntelliVue CL SpO2 Instructions For Use Manual

Assignment with GuardianSoftware
To assign a Cableless Measurement Device to a patient in GuardianSoftware:
Select the patient on the
1
On the
2
Equipment
Click
3

Controls Available with a Patient Monitor

The controls available when the Cableless Measurement Device is assigned to a patient monitor are
described in the table below.
Action
SpO
2
Start SpO
Change SpO
Select SpO
Assign SpO
Remove SpO
Change Alarm Limits
Place Device in Standby
Alarm Silence
Alarm Off/Pause
NBP
Start/Stop/Stat NBP
Change NBP Mode
Change NBP Repetition Time
Change Alarm Limits
Assign NBP Pod
Remove NBP Pod
Place Device in Standby
Alarm Silence
Alarm Off/Pause
WARNING
If a patient being monitored by Cableless Measurement Devices moves out of range of the patient
monitor, the measurements are available on the Cableless Measurement Device only. They are not
transmitted to the patient monitor or the Information Center. If this occurs, the
message is displayed on the measurement device. The measurement device will also sound the INOP
Chalkboard
Equipment List
tab, select the Cableless Measurement Device on the
list.
Use for Patient
to assign the device to the patient.
2
Mode
2
Repetition Time
2
Pod
2
Pod
2
2 Monitoring or Collecting Vital Signs
.
At the Cableless At the Patient
Measurement Monitor
Device
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
No Yes
No Yes
No Yes
No Yes
Yes Yes
Yes Yes
Yes Yes
No Yes
Yes Yes
Yes Yes
No Yes
No Yes
No Yes
Available
At the IIC
No
No
No
No
No
No
Yes
Yes
Yes
Yes
No
No
No
No
No
Yes
Yes
Yes
No Host Monitoring
27