Preparing To Measure Nbp - Philips IntelliVue CL SpO2 Instructions For Use Manual

Table of Contents

Advertisement

Preparing to Measure NBP

1
Attach the cradle to the NBP cuff.
Plug the air tubing into the cradle. Hold the flat part of the connector vertically when plugging it
2
into the inlet, then twist it clockwise to lock into place. Avoid compression or restriction of
pressure tubes. Air must pass unrestricted through the tubing.
Make sure that you are using a Philips-approved correct sized cuff and that the bladder inside the
cover is not folded or twisted.
A wrong cuff size, and a folded or twisted bladder, can cause inaccurate measurements. The width
of the cuff should be in the range from 37% to 47% of the limb circumference.
Apply the cuff to the upper arm at the same level as the heart. If it is not at heart level, you must
3
use the measurement correction formula to correct the measurement.
Apply the cuff so that the cradle is located at the outside of the arm. The bladder of the cuff is
then automatically over the artery. Make sure that the D-ring is not over the artery as this can lead
to missing or inaccurate readings. Do not wrap the cuff too tightly around the limb. It may cause
discoloration, and ischemia of the extremities.
4 Monitoring NBP
41

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IntelliVue CL SpO2 and is the answer not in the manual?

This manual is also suitable for:

Intellivue cl npb

Table of Contents

Save PDF