2 Monitoring or Collecting Vital Signs
tone. No alarms will be available for the measurements when the devices are out of range, as alarms are
only available on the patient monitor.
Keep the patient monitor with the patient during transport.
Controls Available With a Telemetry Device
The controls available when the Cableless Measurement Device is assigned to a TRx4841/TRx4851A
Transceiver or MX40 wearable patient monitor with a short range radio adapter (SRRA) are described
in the table below.
Action
SpO
2
Start SpO
Change SpO
Select SpO
Assign SpO
Remove SpO
Change Alarm Limits
Place Device in Standby
Alarm Silence
Alarm Off/Pause
NBP
Start/Stop/Stat NBP
Change NBP Mode
Change NBP Repetition Time
Change Alarm Limits
Assign NBP Pod
Remove NBP Pod
Place Device in Standby
Alarm Silence
Alarm Off/Pause
NOTE
When you unplug the ECG cable from the telemetry device and plug it into the monitor associated
with the same patient, the ECG source will automatically be from the monitor. The SpO
measurement devices assigned to the telemetry device will continue to source data to the telemetry
device and the Information Center. You may need to change screens on the patient monitor to see the
measurements.
28
2
Mode
2
Repetition Time
2
Pod
2
Pod
2
At the Cableless
Measurement Device
Yes
Yes
Yes
Yes
Yes
No
No
No
No
Yes
Yes
Yes
No
Yes
Yes
No
No
No
At the IIC
Yes
Yes
No
No
Yes
Yes
No
Yes
Yes
No
No
No
Yes
No
Yes
No
Yes
Yes
and/or NBP
2
Need help?
Do you have a question about the IntelliVue CL SpO2 and is the answer not in the manual?