Safety; Safety & Environmental Specifications; General; Warnings And Important Notices - Pro Spot i5 Instruction Manual

i5

2) Safety

2.0 Safety & Environmental Specifications

2.1 General

2.2 Warnings and important notices

!
!
All Info Copyright © Pro Spot International Inc.
The i5 Spot welder is designed for indoor use - Protection Degree IP21S.
The i5 Spot welder is designed to operate from -10º C to 40º C.
The unit may be stored and transported in an ambient temperature from -20º C
to +55º C. The unit can be operated at 95% Relative Humidity (RH). For operation
above 1000m consult the manufacturer. Do not operate the unit on a slope
of more than 10º. The unit meets the requirements of IEC|EN60974-1 2005 third
edition and UL60974-1 2nd edition. E.M.C. classification is C1SPR11.
NOTE: Heating tests were performed at room ambient temperature and the duty
cycle at 40º C has been determined by simulation.
The i5 Spot welder has been designed and is tested to meet strict safety require-
ments. Please read the following instructions carefully before operating the i5 and
refer to them as needed to ensure the continued safe operation of the welder.
Information provided in this manual describes the suggested best working prac-
tices and should in no way take precedence over individual responsibilities or
local regulations.
The i5 Spot Welder is designed to comply with all applicable safety regulations for
this type of equipment. During operation, it is always each individual's responsibil-
ity to consider:
• Their own and other's personal safety.
• The safety of the welder through correct use of the equipment in accordance
with the descriptions and instructions provided in this manual.
By observing and following the safety precautions, users of the i5 Spot welder will
ensure safer working conditions for themselves and their fellow workers.
The following types of safety signs are used on the equipment and in Pro Spot's
instruction manuals:
Caution.
Read instruction manual.
Prohibited.
Prohibits behaviour that
can cause injury.
Command.
Calls for a specific action.
Warning.
Notice of personal injury risk and
or damage to equipment.
Warning.
Some parts of the welder may become
hot after prolonged use.
!
Attention!
Lire Mode d'Emploi.
Interdit.
Interdit aux comportements
qui peuvent provoquer des blessures.
Commande.
Appelle à une action spécifique.
!
Avertissement.
Avis de risque de blessure personnelle
et / ou d'endommager l'équipement.
Avertissement.
Certaines parties du soudeur peuvent devenir
chaudes après une utilisation prolongée.
2 - Safety
Page 5
7