Turning On The Welder - Pro Spot i5 Instruction Manual

i5

4.2.2 Turning On the Welder

Air Pressure
Gauge
1. The 3-phase indicator (3 LEDs on the front panel) should always be illuminated while the welder is plugged in.
Verify this before turning on the power. Switch the circuit breaker on the front panel to "ON".
2. The display will go through the start-up procedure.
3. The i5 is now ready to use.
IMPORTANT! Make sure to read the instruction manual before operating
the welder. Only trained personnel should use this welder.
IMPORTANT! Assurez-vous de lire le Mode d'Emploi avant d'opérer
le soudeur. Seul le personnel qualifié devrait utiliser ce soudeur.
CAUTION:
The i5 discharges a
large magnetic field
when in use which can
negatively effect medi-
cal implant devices
such as pace-makers.
All Info Copyright © Pro Spot International Inc.
14
CAUTION: CAUTION:
The i5 discharges a Unplug the welder
from the wall outlet
large magnetic field
before servicing,
when in use which
cleaning, or mainte-
can negatively effect
nance. Risk for electri-
electronics and attract
cal shock
metal to the gun.
CAUTION:
Some parts of the
welder may become
hot after prolonged
use.
4 - Operation
3 Phase
Indicator
Power Switch
CAUTION: CAUTION:
Always wear eye Be wary of pinch
protection when points on the i5 such
welding. Periodically as the electrodes /
showers of sparks will weld caps on the trans
fly up from the material gun.
being welded.
Page 14