Pro Spot i5 Instruction Manual page 21

i5
4.2.3 i5 Touch Screen Control
Calibration:
Be sure to calibrate in Auto Mode:
• Every 100 welds
• Every arm exchange
• Every time auto mode is entered
• You can NEVER calibrate too often!
Welding / On-Screen Feedback:
CAUTION: Only "OEM" and "Radius Nose" caps should be used in auto mode.
Place the weld gun in the desired position and press the trigger.
After each weld the measured thickness and resistance feed-
back will be displayed on screen. Thickness is displayed in
millimeters, and resistance feedback is given through the
After a weld is made the weld status screen will show. If the weld was performed cor-
rectly then you will be returned to the Auto Weld screen automatically. If there was a
problem with the weld, the status screen will display what went wrong. Press the red
X button to continue.
Settings:
The settings button can be used to modify weld settings. Only users at the advanced and expert levels are
able to access weld mode settings.
WARNING:
Measurement Only Mode:
The caliper icon sets the i5 to measurement only mode. While in measurement only mode the caliper icon
will be highlighted green. Measurement only mode allows you to measure the thickness and resistance of
steel without welding it.
All Info Copyright © Pro Spot International Inc.
To calibrate the i5 for auto detect simply press the calibrate button. The system
will then go through a mock weld cycle.
resistance bar on the right hand of the display.
It is NOT recommended that the factory settings be modified.
CAUTION: During calibration test cycle, the electrodes
will close, creating a pinch point.
Do not calibrate with metal between the
electrodes!
4 - Operation
Page 14
21