Safety Information; Safety & Environmental Speci Cations; General - Pro Spot PHS-101 Instruction Manual

1.0
1.1 SAFETY & ENVIRONMENTAL SPECIFICATIONS
The Hybrid Spot welder is designed for indoor use.
The Hybrid Spot Welder is designed to operate from 10° C to 40° C.
Do not operate the unit on a slope of more than 10°.

1.2 GENERAL

The Hybrid Spot welder has been designed and is tested to meet strict safety requirements. Please read the
following instruction carefully before operating the unit and refer to them as needed to ensure the continued
safe operation of the welder.
Information provided in this manual describes the suggested best working practices and should in no way
take precedence over individual responsibilities or local regulations.
The Hybrid Spot Welder is designed to comply with all applicable safety regulations for this type of equip-
ment. During operation, it is always each individual's responsibility to consider:
• Their own and other's personal safety.
• The safety of the welder through correct use of the equipment in accordance with the descriptions and
instructions provided in this manual.
1.3 WARNINGS AND IMPORTANT NOTICES
The following types of safety signs are used on the equipment and in Pro Spot's instruction manuals:
Caution.
Read Instruction Manual.
Prohibited.
Prohibits behaviour that can cause
injury.
Command.
Calls for a speci c action.
Warning.
Notice of personal injury risk and or
damage to equipment.
Warning.
Some parts of the welder may become hot
long after prolonged use.
SAFETY
OPEN CIRCUIT VOLTAGE AS IT RELATES TO STATE OF CHARGE
Open Circuit Voltage* State of Charge
12.80 or greater.............................100%
12.60..................................75%
12.30..................................50%
12.00..................................25%
12.00....................................0
* The actual stabilized OCV can only be determined after the
battery has been disconnected from the charger for 24 hours.
Battery Warnings
DANGER/POISON
SULFURIC
SHIELD
ACID
EYES.
CAN
EXPLOSIVE
NO
CAUSE
GASES CAN
SPARKS
BLINDNESS OR
CAUSE BLINDNESS FLAMES
SMOKING SEVERE BURNS.
OR INJURY.
KEEP OUT OF REACH OF CHILDREN
All Info Copyright © Pro Spot International Inc.
Attention!
Lire Mode d'Emploi.
Interdit.
Interdit aux comportements qui peuvent
provoquer des blessures.
Commande.
Appelle a une action spéci que.
Avertissement.
Avis de risque de blessure personnelle et /
ou d'endommager l'équipement.
Avertissement.
Certaines parties du soudeur peuvent devenir
chaudes aprés une utilisation prolongée.
READ BEFORE OPERATING WELDER!
Connect all 4 cables to negative
battery terminals Before using.
To access terminals, open right
side cover.
FLUSH EYES
IMMEDIATELY
(The four cables to the negative battery terminals are
WITH WATER.
disconnected during shipping.)
GET
MEDICAL
HELP FAST.
5