Table of Contents
Advertisement
PR-2000
2 Safety
2.0 Safety & Environmental Specifications
2.1 General
2.2 Warnings and important notices
Copyright © Pro Spot International, Inc. 2005-2009
The PR-2000 Spot welder is designed for indoor use - Protection Degree IP21S.
The PR-2000 Spot welder is designed to operate from -10º C to 40º C.
The unit may be stored and transported in an ambient temperature from -20º C
to +55º C. The unit can be operated at 95% Relative Humidity (RH). For opera-
tion above 1000m consult the manufacturer. Do not operate the unit on a slope
of more than 10º. The unit mets the requirements of IEC|EN60974-1 2005 third
edition and UL60974-1 2nd edition. E.M.C. classification is C1SPR11.
NOTE: Heating tests were performed at room ambient temperature and the duty
cycle at 40º C has been determined by simulation.
The PR-2000 Spot welder has been designed and is tested to meet strict safety
requirements. Please read the following instructions carefully before operating the
PR-2000 and refer to them as needed to ensure the continued safe operation of
the welder
Information provided in this manual describes the suggested best working prac-
tices and should in no way take precedence over individual responsibilities or
local regulations.
The PR-2000 Spot Welder is designed to comply with all applicable safety regula-
tions for this type of equipment. During operation, it is always each individual's
responsibility to consider:
• Their own and other's personal safety.
• The safety of the welder through correct use of the equipment in accordance
with the descriptions and instructions provided in this manual.
By observing and following the safety precautions, users of the PR-2000 Spot
welder will ensure safer working conditions for themselves and their fellow work-
ers.
The following types of safety signs are used on the equipment and in Pro Spot's
instruction manuals:
Prohibited.
Prohibits behaviour that can cause injury.
Command.
Calls for a specific action.
Warning.
Notice of personal injury risk and or damage to equipment.
2 Safety
Page 5
Advertisement
Table of Contents
