Safety Devices 2.3.1 Cooling; Cooling - Pro Spot i5 Instruction Manual

i5
2.3 Safety devices

2.3.1 Cooling

COOLING SYSTEM
IMPORTANT! The i5 welder COMES WITHOUT COOLANT to ease transportation. Be sure to fill coolant tank before
turning on the welder! The cooling system turns on and off automatically. It starts at the first weld and shuts off 3 minutes
(or longer if needed) after last weld was completed. Make sure water the lines are connected properly.
The i5 is equipped with a closed
loop cooling system, 5 gallon
(20L) tank, radiator with high
powered fan cooling all the way
to the tip of electrodes.
Make sure the water cooling hos-
es are securely clipped into place
before welding. Water will leak if
water feed and return hoses are
not properly connected. ( See
cooling hoses connections)
Always make sure the welding
arm is installed correctly and the
tightening handle is firmly se-
cured.
IMPORTANT! Turn the power off before disconnecting water hoses from the weld gun.
IMPORTANT! Make sure the water cooling hoses are securely clipped into place before welding.
!
IMPORTANT! The i5 welder comes without coolant to ease transportation, be sure to fill coolant tank before
turning on the welder!
IMPORTANT! If the thermal breaker has switched off the welder, please contact Pro Spot's authorized service personnel
IMPORTANT! N'éteignez pas le soudeur pendant que le système de refroidissement est activé!
IMPORTANT! Si le disjoncteur thermique a éteint le soudeur, s'il vousplaît contactez personnel de service autorisé Pro Spot.
All Info Copyright © Pro Spot International Inc.
BEFORE WELDING
The coolant tank is located in the rear of the unit, inside the center column.
It should be filled with a 50/50 water & antifreeze solution. Be sure to turn
off the i5's power before filling the coolant tank or changing weld arms to
prevent spillage. Maintain a level of at least 11L of 50/50 solution at all
times and do not over fill. When filling coolant it is recommended that a
funnel be used to prevent unnecessary spills. Avoid contact of skin, eyes,
or mouth with the antifreeze or 50/50 solution. See antifreeze directions for
proper handling instructions.
2 - Safety
Coolant Refill Cap
Located in the upper right hand
side on the back of the i5. Make
sure that the cap is securely
tightened before welding after
filling the tank. It is recommend-
ed that a funnel be used when
filling to prevent spillage.
Coolant Level Indicator
Located in the lower right hand
side on the back of the i5. Be
sure to check the coolant levels
regularly to maintain an opti-
mum of 11L minimum in the
tank.
Page 7
9