Installing And Configuring The Unit; Installing The Unit - Dentsply Sirona Primeprint Instructions For Use Manual

Dentsply Sirona
Instructions for Use Primeprint
67 45 173 D3691
D3691.201.01.01.02 04.2021
5.3.6

Installing and configuring the unit

5.3.6.1

Installing the unit

You must connect the unit to the PC before putting it into operation.
This is described in the section "Connecting the PC/interfaces".
IMPORTANT
The Primeprint unit can be operated with both a static as well as an
automatically assigned IP address.
The Primeprint unit is always configured for operation ex works with a
static IP address. The standard IP address is as follows:
192.168.230.xy. The digits x and y are made up from the last two
digits of the unit serial number. These can be found on the label on
the rear of the device If the serial number ends in "00" then the xy
value is always"100".
The MAC address for the network card can be found on the
machine's configuration menu.
To change the IP configuration always establish a direct connection
with static IP address to your PC's network card. The network
address for the inLab 6 PC used is 192.168.230.101. The subnet
mask is 255.255.255.0.
5.3.6.1.1 Automatic unit search
ü The unit is connected to the PC using a direct connection via
Ethernet cable.
ü The unit is switched on.
1. Start the "inLab CAM" software.
2. Click on the "Machine and Instrument tray Management" button in
the system menu.
3. Click on the "Scan for New Devices" button.
Ä All units connected to the PC are recognized.
4. Enter a name for the new unit.
5.3.6.1.2 Manual unit search
ü The unit is connected to the PC using a direct connection via
Ethernet cable.
ü The unit is switched on.
1. Start the "inLab CAM" software.
2. Click on the "Machine and Instrument tray Management" button in
the system menu.
3. Click on the "Add Device (Manual)" button.
4. Select "Network" .
5. Enter the network address.
6. Click on the "Ok" button.
Ä The software attempts to contact the device.
If the connection fails, check the connection. If necessary, ask a
qualified technician.
5 Commissioning
5.3 Putting the unit into operation
43