Production Process; Equipping The Primeprint Material Unit; Loading With Material Unit - Dentsply Sirona Primeprint Instructions For Use Manual

6 Operation

6.2 Production process

48
Production process
6.2
3D printing is done on the build platform, which is placed in the 3D
printer with the Primeprint material unit.
6.2.1

Equipping the Primeprint material unit

The Primeprint material unit consists of the lower material unit vat and
the upper material unit cover.
The desired cartridge is inserted into the Primeprint material unit. The
cartridge is supplied with a material unit sticker, which is applied to the
left side of the material unit vat. This allows a visual classification of the
vat and significantly simplifies operation later on.
The cartridge must be preconditioned before it is inserted into the
material unit. First, shake the cartridge for about 10 seconds so that the
contents are well mixed. The sealing film of the cartridge must then be
removed to vent the cartridge.
6.2.2

Loading with material unit

CAUTION
Risk of injury when reaching into the build chamber
There is the risk of cut and crush injuries caused by sharp edges and
movable parts.
➢ Be sure not to touch the sharp edges and movable parts.
During each change, ensure clean contact surfaces of all parts;
otherwise, the fixation and the correct positioning cannot be
guaranteed. Depending on your choice of materials, also follow the
processing instructions of the manufacturer.
NOTE
Make sure that you only process material whose expiration date has
not passed.
To load the 3D printer with the Primeprint material unit, follow these
steps:
ü The job is shown on the touch display and you are prompted to
insert the appropriate material unit.
1. Follow the instructions of the 3D printer on the display.
Dentsply Sirona
Instructions for Use Primeprint
67 45 1 73 D3691
D3691.201.01.01.02 04.2021