Accessories; In Case Of Damage; Electromagnetic Compatibility; Electromagnetic Emission - Dentsply Sirona Primeprint Instructions For Use Manual

Dentsply Sirona
Instructions for Use Primeprint
Emission measurement
RF emissions according to CISPR 11
RF emissions according to CISPR 11
Harmonics
according to IEC 61000-3-2
Voltage fluctuations / flicker according
to IEC 61000-3-3
67 45 173 D3691
D3691.201.01.01.02 04.2021
2.1.4

Accessories

In order to ensure product safety, this device may be operated only with
original Dentsply Sirona accessories or third-party accessories
expressly approved by Dentsply Sirona. In particular, only the power
cable also supplied or the corresponding original spare part may be
used with the unit. The user is responsible for any damage resulting
from the use of non-approved accessories.
2.1.5

In case of damage

In case of noticeable malfunctions or damage, stop using the instrument
immediately and notify your authorized dealer or the manufacturer.

Electromagnetic compatibility

2.2
Observance of the following information is necessary to ensure safe
operation regarding EMC aspects.
Primeprint complies with the requirements for electromagnetic
compatibility (EMC) according to DIN EN 61326-1:2013
Primeprint is hereinafter referred to as "UNIT".
2.2.1

Electromagnetic emission

The UNIT is intended for operation in the electromagnetic environment
specified below.
The customer or user of the UNIT should make sure that it is used in
such an environment.
Conformity
Group 1
Class B
Class A
coincides
2.2 Electromagnetic compatibility
Electromagnetic environment - guidelines
The UNIT uses RF energy only for its internal
function. Therefore, its RF emissions are very low
and are not likely to cause any interference in
nearby electronic equipment.
The UNIT is intended for use in all facilities, in-
cluding residential areas and in any facilities con-
nected directly to a public power supply providing
electricity to buildings used for residential pur-
poses.
2 Safety instructions
13