Dentsply Sirona Primeprint Instructions For Use Manual page 39

Dentsply Sirona
Instructions for Use Primeprint
67 45 173 D3691
D3691.201.01.01.02 04.2021
Positioning the access point
1. As a test, place the access point near the production unit at head
level or higher.
2. Perform a communication test as described in the separate
instructions (see "Operating MC XL via WLAN in infrastructure
mode", section "Final work, analyzing connection quality"). If
applicable, follow the instructions on changing channels.
3. After you have found the optimum setting, take the acquisition unit
and place it in the position in which it will be operated that is farthest
away from the access point.
4. From this position, repeat the communication test you conducted
earlier. If the results are satisfactory, leave the access point
permanently in this position.
5. If the results are not satisfactory, position the access point outside
of the room in which the production unit is located and repeat the
communication test.
Ä If the connection quality is still not adequate, WLAN
communication cannot be easily achieved under the local
conditions. In this case, ask your network administrator for
assistance.
NOTE
LAN connection
Operation via a LAN cable connection is possible at any time.
5 Commissioning
5.2 Connection to the PC of the acquisition unit
39