Loading With Primeprint Box - Dentsply Sirona Primeprint Instructions For Use Manual

6 Operation
6.2 Production process
50
6.2.3

Loading with Primeprint box

CAUTION
Risk of injury when reaching into the build chamber
There is the risk of cut and crush injuries caused by sharp edges and
movable parts.
➢ Be sure not to touch the sharp edges and movable parts.
During each change, ensure clean contact surfaces of all parts;
otherwise, the fixation and the correct positioning cannot be
guaranteed. Depending on your choice of materials, also follow the
processing instructions of the manufacturer.
To load the 3D printer with the Primeprint box, follow these steps:
ü The job is shown on the touch display and you are prompted to
insert a prepared Primeprint box.
ü For information on preparing and cleaning the build platform, refer
to section 5.2.5 (Preparing the Primeprint box).
1. Follow the instructions of the 3D printer on the display.
2. Rotate the holder for the Primeprint box by approx. 45° out of the
printer.
3. Place the prepared Primeprint box in the guide rails of the holder.
4. Push the Primeprint box into the holder until the unit clicks
noticeably into place.
Dentsply Sirona
Instructions for Use Primeprint
67 45 1 73 D3691
D3691.201.01.01.02 04.2021