Operation; Referencing Run - Dentsply Sirona Primeprint Instructions For Use Manual

Dentsply Sirona
Instructions for Use Primeprint
67 45 173 D3691
D3691.201.01.01.02 04.2021
6

Operation

Referencing run

6.1
NOTE
Observe the Operator's Manual
Please also observe the information in the Operator's Manual for
inLab CAM SW software.
The referencing run is used for the function check of the sensors and
the position check of movable parts in the build chamber. The
referencing run takes place automatically via the firmware. The
complete referencing run always takes place following switch-on of the
machine immediately before starting the first job. The shortened
referencing run takes place before every new job.
6 Operation
6.1 Referencing run
47