Omron NXEIP202 User Manual page 379

General status
code (hex)
14
15
16
17
18
19
1A
1B
1C
1D
1E
1F
20
21
22
23-24
25
26
NX-series EtherNet/IP Coupler Unit User's Manual (W536)
Status name
Attribute not supported
Too much data
Object does not exist
Service fragmentation sequence not in
progress
No stored attribute data
Store operation failure
Routing failure (request packet too
large)
Routing failure (response packet too
large)
Missing attribute list entry data
Invalid attribute value list
Embedded service error
Vendor specific error
Invalid parameter
Write-once value or medium already
written
Invalid Reply Received
---
Key Failure in path
Path Size Invalid
Description
The attribute specified in the request is not sup-
ported.
The service supplied more data than was expected.
The object specified does not exist in the device.
The fragmentation sequence for this service is not
currently active for this data.
The attribute data of this object was not saved prior
to the requested service.
The attribute data of this object was not saved due
to a failure during the attempt.
The service request packet was too large for trans-
mission on a network in the path to the destination.
The routing device was forced to abort the service.
The service response packet was too large for
transmission on a network in the path from the des-
tination. The routing device was forced to abort the
service.
The service did not supply an attribute in a list of
attributes that was needed by the service to per-
form the requested behavior.
The service is returning the list of attributes sup-
plied with status information for those attributes that
were invalid.
An embedded service resulted in an error.
A vendor specific error has been encountered. The
Additional Code Field of the Error Response
defines the particular error encountered. Use of this
General Error Code should only be performed
when none of the Error Codes presented in this
table or within an Object Class definition accurately
reflect the error.
A parameter associated with the request was
invalid. This code is used when a parameter does
not meet the requirements of this specification
and/or the requirements defined in an Application
Object Specification.
An attempt was made to write to a write-once
medium (e.g. WORM drive, PROM) that has
already been written, or to modify a value that can-
not be changed once established.
An invalid reply is received (e.g. reply service code
does not match the request service code, or reply
message is shorter than the minimum expected
reply size). This status code can serve for other
causes of invalid replies.
Reserved by CIP for future extensions
The Key Segment that was included as the first
segment in the path does not match the destination
module. The object specific status shall indicate
which part of the key check failed.
The size of the path which was sent with the Ser-
vice Request is either not large enough to allow the
Request to be routed to an object or too much rout-
ing data was included.
Appendices
A
A - 31