Omron NXEIP202 User Manual page 369

Format for Error Response
Parameter name
Reply Service
Reserved
General Status
Size of Additional Status
Additional status
*1. If the general status code in the response code is 0x1F (Vendor specific error), the value is 0x01.
*2. This is stored only when the value of Size of Additional Status is 0x01.
CIP error code
General status code (hex)
02
10
13
15
1F
20
*1. Refer to General Status Code on page A-30 for error descriptions.
Class IDs and Instance IDs
The class ID and instance ID are given in the following table.
ID type
Class ID
Instance ID
Attribute IDs
The instance attribute IDs are given in the following table.
Attribute ID
(hex)
01
02
NX-series EtherNet/IP Coupler Unit User's Manual (W536)
Reply to Initialize unit operation parameter
service
Reserved
Current error code defined by CIP
Size of Additional status
Additional status
Value (hex)
74
01
Parameter
Description
name
NX PDO total EtherNet/IP maximum
output size I/O connection output
*1
size
NX PDO total EtherNet/IP maximum
input size I/O connection input
*3
size
Description
Error code
Resource unavailable
Device state conflict
Not enough data
Too much data
Vendor specific error
Invalid parameter
Attribute
Read UINT
Read UINT
Appendices
Data
Value (hex)
type
USINT BD
USINT 00
USINT Current error code
USINT *1
00
UINT
Additional status
*1
Data
Value (hex)
type
*2
0000 to 01F8
*1
0000 to 01F8
*2
A
A - 21