Omron NXEIP202 User Manual page 358

Appendices
Parameter name
Unit No
Format for Normal Response
Parameter name
Reply Service
Reserved
General Status
Size of Additional Status
Format for Error Response
Parameter name
Reply Service
Reserved
General Status
Size of Additional Status
Additional status
*1. If the general status code in the response code is 0x1F (Vendor specific error), the value is 0x01.
*2. This is stored only when the value of Size of Additional Status is 0x01.
CIP error code
General status code (hex)
02
10
13
15
1F
20
*1. Refer to General Status Code on page A-30 for error descriptions.
*2. A vendor specific error will occur if you execute this service for an NX Unit that does
not support restarting.
 Save Parameter (Service Code: 36 Hex)
The request format, format for normal responses, format for error responses, and CIP error codes
for the Save parameter object are given below.
Request Format
Parameter name
Service
Request Path Size
Request Path
A - 10
Description
Unit number UINT
Description
Reply to Restart NX unit service
Reserved
Code that indicates normal
Size of Additional status
Description
Reply to Restart NX unit service
Reserved
Current error code defined by CIP
Size of Additional status
Additional status
Description
Service code USINT
Request path size USINT
Request path Padded EPATH
Data type
0000: Communications Coupler Unit
0001 to 003F: NX Unit
0040 or higher: Not supported.
Data Value
type (hex)
USINT B5
USINT 00
USINT 00
USINT 00
Data
type
USINT
USINT
USINT
USINT
UINT
*1
Error code
Resource unavailable
Device state conflict
Not enough data
Too much data
*2
Vendor specific error
Invalid parameter
Data type
36
02
20742401
NX-series EtherNet/IP Coupler Unit User's Manual (W536)
Value (hex)
Value (hex)
B5
00
Current error code
*1
00
*2
Additional status
Value (hex)