Omron NXEIP202 User Manual page 238

9 Setting Up Slave Terminals
• Do not disconnect the Ethernet cable or reset or turn OFF the power to the EtherNet/IP Unit
during the parameter download.
• Tag data links (data exchange) between relevant nodes is stopped during a download.
Before you download data in RUN mode, make sure that it will not affect the controlled sys-
tem. Also implement interlocks on data processing in ladder diagram programming that uses
tag data links when the tag data links are stopped or a tag data link error occurs.
• For EtherNet/IP Units with revision 1, you can download tag data link parameters only when
the CPU Unit is in PROGRAM mode.
• Even for Units with revision 2 or later, all CPU Units must be in PROGRAM mode to down-
load the parameters if any Units with revision 1 are included in the network.
1
Connect the Network Configurator online.
2
There are two ways to download the parameters.
Downloading to All Devices in the Network
Select Network - Download.
The following dialog box is displayed:
Downloading Individually to Particular Devices
Select the icon of the EtherNet/IP Unit to which you want to download. To select multiple nodes,
hold down the Shift Key while you click the icons. (In the following example, 2 nodes are
selected: 192.168.250.2 and 192.168.250.1.) Right-click the icon to display the pop-up menu,
and select Parameter - Download.
The following dialog box is displayed.
9 - 64
NX-series EtherNet/IP Coupler Unit User's Manual (W536)