Adapter Board Pm Connectors; Ml310 Pm Utility Pins; Contact Order - Xilinx ML310 User Manual

R

Adapter Board PM Connectors

ML310 PM Utility Pins

Contact Order

64
All manuals and user guides at all-guides.com
•
1 single-ended clock at 2.5V
•
1 pin not connected
Tyco Z-Dok+ adapter board connectors, part number 1367555-1 are the receptacle
connectors on the personality modules that mate to the ML310 Tyco Z-Dok+ host board
connectors, part number 1367550-5. The Tyco data sheet for part number 1367555-1 is
available at http://www.z-dok.com/documents/1367555.pdf.
On the adapter board connectors, located on the personality module, each signal pair has
a pair of ground pins on the opposite side of the open space, as shown in
signal pairs alternate from side to side along the length of the open space. All of the "B" and
"E" pins are two contacts tied together and grounded on the personality module. The "A",
"C", "D", and "F" pins are signal pins.
Figure 2-22: Adapter Board Connector Pin Detail
The Z-Dok+ power and ground pins contact in the following order:
•
1 and 6;
•
then 2 and 5;
•
then 3 and 4
Chapter 2: ML310 Embedded Development Platform
Copper Pins
www.xilinx.com
1-800-255-7778
Figure 2-22. The
Plastic Housing
ML310 User Guide
UG068 (v1.01) August 25, 2004