Analog Input / Output Terminals Connection - Unipulse F377A Operation Manual

■Analog input / output terminals connection

How to connect
1.
Strip 5mm of the covering of the wire to be
connected.The size of connectable wires is
from 0.21 to 3.31mm
2.
Twist the tip to such an extent that it will not spread out.
3.
Loosen the screw with a screwdriver to open
the connection hole.
A Phillips screwdriver 3 to 3.5mm #1 in shaft
diameter is recommended.
(Precision screwdriver, etc.)
4.
Insert the wire into the connection hole so as
not to let the tip spread out.
5.
Tighten the screw with the screwdriver.
0.5Nm of tightening torque is recommended.
6.
Lightly pull the wire to make sure that it is securely clamped.
7.
Insert the wire-connected plug into the
F377A body, and tighten the screws (two).
How to remove the terminal block
1.
Loosen the screws (two) with a screwdriver.
2.
Remove the terminal block by giving it a
strong pull.
Attention
When installing the terminal block to the F377A body,
check its orientation. (See the illustration at the right.)
2
(AWG12 to 24).
2 INSTALLATION & CONNECTION
5mm
Pin No. 7
Loosen.
(Turn counterclockwise.)
Tighten.
(Turn clockwise.)
Pin No. 1
Adaptable plug ETB42-07P (attachment)
We sell it as CN80 (optional).
Tighten.
(Turn clockwise.)
Tighten.
(Turn clockwise.)
Loosen.
(Turn
counterclockwise..)
Loosen.
(Turn
counterclockwise..)
Right side
Chapter
2
Pin No. 7
Pin No. 1
Insert side
19