Average Time On Digital Zero; Run Output Selection - Unipulse F377A Operation Manual

4 EXP. OPERATION FUNCTIONS
Chapter
4

■Average time on digital zero

0.000 to 5.000 sec
How to set
SET.
Inputting 0.001 sec. or more makes the above operation effective.
4-3.

RUN Output Selection

You can select the output form of the external output signal RUN (A9).
■RUN output selection
ON-OFF operation / ON fixed / OFF fixed
How to set
SET.
128
Example) Time specified section average hold
Section (1)
DZ
Averaging by the Average Time On Digital Zero
starts at the time when Digital Zero is executed.
Exp. Setting
→
CAUTION
In the case of using ZT (Zero Tracking) with this function effective,
averaging is also performed.
- ON-OFF operation See "5-21.RUN Output" in the operation manual (Standard) of the F377
- ON fixed
OFF
RUN
ON
OFF
RUN
ON
Error factor removal
- OFF fixed The ON-OFF relationship is the inverse of the ON-fixed case.
Exp. Setting
→
CAUTION
Be aware that judgment is difficult if a hardware error occurs (if the level is fixed
for some reason) when the output is fixed.
Hold Section
Time
Initial value: 0.000 sec
Exp. Operat. Set.
→
Turns OFF when an error occurs.
3.0sec
Turns ON in 3.0 sec. by the error factor removal.
Initial value ON-OFF operation
Exp. Operat. Set.
→
Upon completion of averaging, the ave
rage result is subtracted from the value
indicated at that time.
Page 1
→
Page 1
→