Table of Contents
Advertisement
7 SPECIFICATIONS
■Standard interfaces
RS-232C communication interface
SI/F (2-wire serial interface)
■Options interfaces
BCD data output
D/A converter
■External input and output
Chapter
7
Output
HI-LO limit comparison output
Normal operation output
Hold end output
Graph plotting end output
Input
Work selection input
Hold control input
Digital zero input
Graph plotting control input
Calibration Selection input
■General
Power source
Power consumption
Rush current (Typ)
Operating conditions Operation temperature:
Warmup time
80
Start/stop system
Baud rate: 9600bps～57600bps
Start/stop system
Baud rate: 600bps
Open collector
Output rate
Can be selected from 10, 20, 50, 100, 200, 500, 1000 and 2000 times/sec.
Capacity
30V, 30mA
Voltage output (DAV)
－10 - +10V
Current output (DAI)
4 - 20mA
Zero output and full scale output can be digitally adjusted.
Zero adjusting range:
±10%FS
Gain adjusting range:
±10%FS
Zero drift:
Within 0.6mV/℃ (DAV)
Within 0.5μA/℃ (DAI)
Gain drift:
Within 50ppm/℃
Non-linearity:
0.05%FS
Response:
Dependent on the A/D conversion speed
(2000 times/sec.) of the main unit
- HH, HI, OK, LO, LL
- RUN
- H/E
- EVENT
- WORK0, WORK1, WORK2, WORK3
- T/H, SECTION
- DZ
- GRAPH TRIG
- CAL0, CAL1
- DC spec
DC24V (±15％)
- DC spec
18W max
55A, 1msec (ordinary temperature, at cold-start time)
Storage temperature:
Humidity:
20 minutes
RL>2kΩ
RL<350Ω
－10℃～40℃
－20℃～60℃
85％RH or below (non-condensing)
Advertisement
Table of Contents
