3-5. Connecting Analog monitor Output (VOL OUT)
Terminal for out put of a voltage proportional to the sensor input .
Output voltage is approx. 2V per 1mV/V(sensor input).
• Since the VOL OUT terminals are not insulated from internal circuits,
• Do not short-circuit them. Doing so will cause a failure.
• Do not apply external voltages. Breakage will result.
F320
← Inside
Outside →
A8
A9
use shielded cables for connection with an external device, and carry
out wiring within 2 to 3m.
SIG
+
External device
-
Load resistance
2kΩor above
GND
CAUTION
3.CONNECTION
20