Table of Contents
Advertisement
1 EXP. HOLD FUNCTIONS
1-5.
Renewal of Hold Value
Chapter
1
You can change the operation of renewing the hold value display.
All Time / Hold Stop
How to set
SET.
114
Exp. Setting
→
- All Time:
When detection starts, the previous hold value is canceled and the indicated
value is displayed by tracking. When the hold condition is met, the indicated
value is held.
- Hold Stop:
When detection starts, the previous hold value is maintained, and no tracking
state is displayed. If the hold condition is met when the Hold Section ends, the
hold value is renewed. This is, however, effective only when Hold Auto Reset
is ON.
- In the case of Peak hold
All-Time Renewal
SECTION
T/H
H/E
Hold-Stop Renewal
SECTION
T/H
H/E
A tracking state is restored by inputting T/H.
Hold Start
Level
Section time
SECTION
T/H
H/E
Initial value: All Time
Exp. Hold Set.
→
→
Numerical changes in Hold
Action can be seen because the
hold value is canceled when
detection starts.
Hold value changes can simply
be seen because the hold value
is maintained during detection.
Hold-Stop Renewal & Hold Auto
Reset & Level Trigger
For example, if the Hold Section
is set to "Level + Time," hold
detection is performed with no
Section Time
external signal, and only the
hold value is displayed.
Page 1
Advertisement
Table of Contents
