Height Adjustment And Disassembly Of The Multi-Level Hitch Attachment Tail Piece; Front Three-Point Hitch; Lifting Force Of The Front Three-Point Hitch - Zetor UTILIX CL Operator's Manual

Height Adjustment and Disassembly of the Multi-level Hitch Attachment Tail Piece

Remove the rear PTO cover and, if necessary, the lower
hitch before handling the multi-level hitch attachment tail
piece. Grasp the multi-level hitch attachment tail piece
firmly. Moving the lever (1) in the direction of the arrow
(upwards) engages the locking pins (2) and the tail piece
is freely movable in the grooves of the multi-level console.
Adjust the multi-level hitch attachment tail piece to
a suitable height so that the locking pins (2) are aligned
with the holes in the multi-level hitch console and release
the lever (1); the locking pins (2) slide into the holes in the
multi-level hitch console. Check that the pins (2) slightly
overlap the outer edge of the multi-level console. Perform
the disassembly of the multi-level hitch attachment tail
piece after pulling the lever (1), by sliding the tail piece
upwards out of the grooves of the multi-level console.
Perform the assembly in the reverse order.

* Front Three-point Hitch

It is used for attachment of front mounted implements and
tools with hitch points of category I according to ISO.
Note: The required width of the front hydraulic arms can be adjusted to a certain extent by
adjusting the end points.
More information in the Operatorʼs manual of the front three-point hitch manufacturer.

Lifting force of the front three-point hitch

Lifting force
Front 700 kg
TRACTOR CONTROLS
UCL18NN008
UCL18NN005
69