Mounting Implement - Zetor UTILIX CL Operator's Manual

Mounting Implement

If the PTO is used, remove the safety cover (1) from the PTO shaft.
Connect the lower left link, then connect the lower right link using the adjusting handle, if necessary.
Connect the upper link.
Connect the PTO shaft to the tractor, if used, and make sure it is properly locked in place.
Adjust the stabilizer bars so that it corresponds to the implement and tighten the retaining nuts.
To disconnect the implement, proceed in the reverse order.
When not in use, lubricate the PTO shaft with grease and
install a cap.
Caution: Do not attach a PTO shaft with the engine running and ensure all safety shields are in
place.
Under no circumstances should the rotational speeds specified by the implement
manufacturer be exceeded, as this may result in serious damage to the tractor/equipment and
serious injuries to bystanders.
Read the operating and maintenance manual of the implement carefully before operating it.
The measures must be taken to ensure that
there are not bystanders around the tractor while
working with a PTO-driven implement. Rotating
blades of the implement can cause serious injuries.
When not in use, install a protective cap on the PTO
shaft.
TRACTOR CONTROLS
U18N048
U18N055B
63