Height Adjustment And Disassembly Of The Multi-Level Hitch Attachment Tail Piece; Air Brakes - Zetor HORTUS HS Series Operator's Manual

Height Adjustment and Disassembly of the Multi-level Hitch Attachment Tail Piece

Remove the rear PTO cover and, if necessary, the lower
hitch before handling the multi-level hitch attachment tail
piece. Grasp the multi-level hitch attachment tail piece
firmly. Moving the lever (1) in the direction of the arrow
(upwards) engages the locking pins (2) and the tail piece
is freely movable in the grooves of the multi-level console.
Adjust the multi-level hitch attachment tail piece to
a suitable height so that the locking pins (2) are aligned
with the holes in the multi-level hitch console and release
the lever (1); the locking pins (2) slide into the holes in the
multi-level hitch console. Check that the pins (2) slightly
overlap the outer edge of the multi-level console. Perform
the disassembly of the multi-level hitch attachment tail
piece after pulling the lever (1), by sliding the tail piece
upwards out of the grooves of the multi-level console.
Perform the assembly in the reverse order.
Caution
Maximum horizontal load (D) - 42.8 KN

Maximum permitted vertical load - 1,200 kg


* Air Brakes

On request, the tractor can be equipped with dual-hose air brakes. In this case it is necessary to connect
both ends of the trailer air brakes to the corresponding counterparts (color coded). Always make sure the air
brake hose ends are properly connected. Incorrect connection can result in serious accident and injury. If
you have any doubts, contact your dealer / authorized service center.
Dual-hose Brakes
The left hose flap (1) is marked yellow (braking line), the
right hose flap (2) is marked red (filling line).
ATTENTION: Failure to connect or incorrectly connect the air brake hoses can result in serious
injury and a traffic accident. Always check the correct connection.
DESCRIPTION OF TRACTOR CONTROLS
UCL18NN008
67