Upper Link Adjustment - Zetor UTILIX CL Operator's Manual

Upper Link Adjustment

1 - Upper Link
2 - Length Adjustment Handle of the Upper Link. Extending or shortening the upper link changes the angle of
the implement.
After adjustment, secure the adjustment handle with its
mounting nut.
The locating hole of the top link varies with the type of
implement used.
1) The most common locations are the 1st and 2nd hole
from the top (1).
2) For general implement: Use the Pin to Position 3 point.
3) For Draft control: Use the Pin to Position 2 point.
Adjustment of the stabilizer bars
The stabilizer bars are designed to limit or prevent lateral
movement of the implement.
No clearance is permitted when transporting implements
and when working on slopes, with rollers, mowers,
seeders, drills and similar implements (position 1).
However, a slight clearance (position 2) is necessary
when working with plows, harrows, excavators, cultivators,
etc., especially when working with draft control.
The length of the stabilizer bars is adjusted after removal
of the pin by turning the tensioner through which the
threaded plugs are connected.
Adjustment of the lower links of the three-point hitch
1 - Vertical link
Adjustment is made using the adjustment handle of the
right vertical link.
Turn the handle clockwise to retract and turn the handle
counterclockwise to extend.
After proper adjustment, secure the handle against
spontaneous rotation.
TRACTOR CONTROLS
U18N043
U18N044
UCL18N037
UCL18N040
65