Check And Change Of Coolant; Check Of Coolant; Change Of Coolant - Zetor UTILIX CL Operator's Manual

Check and Change of Coolant

Check of Coolant

Do not open the radiator cap if the engine is hot. Otherwise, hot steam can cause serious
Remove the radiator cap and make sure that the coolant
reaches up to the filler neck and that it is clean. Check that
the correct antifreeze or anti-corrosion mixture is used.
1 - Radiator Cap
2 - Expansion Vessel
If corrosion of the cooling system is noticeable in the
coolant color, completely drain the system and fill with the
correct mixture of water and antifreeze or corrosion
inhibitor.
1 - Drain Valve

Change of Coolant

1. Set the heating tap to the open position, open the drain
tap.
2. At the same time, open the radiator cap.
3. For thorough cleaning, rinse the cooling circuit with
running water.
4. Close the tap and fill the radiator with coolant, i.e.
a mixture of water and an anti-corrosion inhibitor or
antifreeze solution.
5. Start the engine and let it run for about 5 minutes,
check the fluid level again and top up if necessary.
Caution: Do not remove the radiator cap while the engine is hot.
Allow the engine cool down and then turn the cap slowly to make sure that there is no excessive
pressure in the radiator.
MAINTENANCE
.
UCLS5N013
UCL18N055
CCL3540040
85