Pto Control Switches - Zetor UTILIX CL Operator's Manual

PTO Control Switches

PTO Selector Switch
This switch is located near the starting key location on the dash panel. There are four positions marked for
this switch.
1. OFF - The PTO shaft is stopped.
2. Auto - (Automatic) When the implement is raised to the
preset height, the PTO shaft stops automatically.
3. Manual - The PTO shaft rotation status can be
controlled by manually switching the PTO switch to the
ON / OFF position.
4. Intension mode - On intension mode, PTO keep
rotating even operator leaves from the seat.
PTO Switch (ON/OFF)
It is used to turn the PTO on/off in conjunction with the PTO selector switch.
ON - Pressing the switch turns on the red indicator light
and the PTO shaft rotates.
OFF - Pressing the switch again turns off the indicator
light and the PTO shaft stops rotating.
The PTO indicator lighton the instrument panel indicates the PTO status.
1. If the indicator light is on: PTO rotates.
2. If the indicator light is off: PTO is off.
3. If the indicator flashes: PTO is not currently in motion, but shall be activated when the clutch pedal is
released or the implement is lowered.
TRACTOR CONTROLS
UCLS5N006
UCLS5N007
45