Change - Zetor UTILIX CL Operator's Manual

Change

To drain the oil from the front axle, unscrew the drain plugs on the bottom side of the axle and on the
left/right reducer.
After draining the oil, screw the drain plugs back and tighten them, check for leaks.
Remove the front axle filler cap and fill with new oil that does not exceed the maximum level indicated by the
mark.
1 - Level gauge & oil filler
2 - Front axle oil drain plug
Always use the prescribed oil, as using different types of oils or oils with different
specifications can cause damage.
Only add the prescribed amount of oil.
At the end of its service life, dispose of the oil in accordance with applicable regulations.
1 - Top plug (Vent plug)
Important:
After refilling the prescribed amount of new oil, the level measured by the dipstick may be higher
than permitted - due to incomplete filling of the front-wheel axle drive mechanism - this discrepancy
will disappear after being put back into operation. Unscrew the bleed plugs to accelerate the proper
pumping of the oil by the front axle drive system.
90
MAINTENANCE
U18N079
UCL18N066