Implement Installation - Zetor COMPAX CL Series Operator's Manual

Implement Installation

When using the PTO, remove the safety cover from the PTO shaft. Adjust the yoke of the lift link on the lower
link to suit the used implement. Attach the left lower link, then attach the right lower link, if necessary using
the adjustment handle on the alignment box. Connect the upper link. Connect the PTO shaft to the tractor, if
it is to be used, and make sure it is properly locked in place. Adjust the stabilizer chains to suit the implement
and tighten the lock nuts. Use the reverse procedure to remove the implement.
1 - Safety Cover
Warning:
Do not connect the PTO shaft while the engine is running.

Make sure all safety covers are in place.

CONTROLS, INSTRUMENTS & OPERATIONS
57