Pto Selection Control Lever; Lever Of Shifting Of Speed 540 (Or 540E) And 1,000 Rpm Of The Rear Output Shaft; Lever Of Hand Brake And Hitch For Single-Axle Trailer - Zetor PROXIMA GP Series Operator's Manual

PTO selection control lever

a - independent revolutions of the PTO shaft drive - revolutions are dependent on the engine revolutions
n - neutral position
b - dependent revolutions of the PTO shaft drive through the gearbox - revolutions are dependent on the
shifted gear
Shifting is performed when the tractor is idling.
The neutral position of the gear shift lever of dependent and independent revolutions is indicated with the
symbol N (1) on the display of the instrument panel.
When the tractor is operated and the rear PTO shaft is not used, the gear shift lever of
dependent and independent revolutions must always be in the neutral position (n).
Shifting can be carried out when the tractor is in standstill
by pulling up or pushing down the lever.
a - 1,000 min -1
(or 540E min
b - 540 min -1
Shifting of 540 and 1,000 (or 540E) min
possible regardless to the number of grooves on the
installed termination. Speed of the output shaft and
type of the termination shall be chosen depending on
the prescribed speed of the aggregated machine.

Lever of hand brake and hitch for single-axle trailer

1. Hand brake lever.
2. Lever of the single-axle trailer hitch control.
When stopping or leaving the tractor you must
always secure the tractor with the parking brake.
If the tractor is standing on a slope, its wheel must be
additionally secured with wedges!
52
ACQUAINTANCE WITH TRACTOR
P18N016
-1
)
-1
is
PGPPN162
PGPPN163