Independent Pto; The Pto Monitor Lamp; Pto On / Off Switch; Pto Control Switch - Zetor HORTUS HS CL Operator's Manual

Independent PTO

It must be noted that the PTO shift lever on the LHS below
the driver seat should be shifted to position 1 (540 RPM)
0r 2 (750 RPM) depending upon the implement
specification.
In no case the specified speeds be crossed as serious
damage to the tractor / implement to person can result
because of this.
When the PTO is not in use the shift lever must be put in
neutral position to avoid unnecessary use or accidental
use.
1 - PTO ON/OFF button
2 - Key S/W
3 - PTO Mode S/W

The PTO Monitor Lamp

The PTO monitor lamp on the dash panel indicates the
state of the PTO shaft.
1. If the monitor glows: The PTO is rotating.
2. If the monitor is off: The PTO is off.
3. If the monitor blinks: The PTO is presently
stationary but will instantly start rotating of the
clutch pedal is released or the implement is
lowered.

PTO On / Off Switch

Two switches operate the independent PTO.
PTO ''On / Off'' switch: PTO ''On / Off'' switch is situated
on the LHS. on the steering column and can be identified
easily with its built in red colored indicator.
When the switch is pushed down to start the PTO
indicator glows to indicate that the switch and the PTO are
in ''On'' position, if the switch is pushed down again the
indicator goes off signaling that the PTO is ''Off''.

PTO Control Switch

This switch is situated near the starting key location on the
dash panel. There are three positions marked for this
switch.
''Off'' at the center.
''Manual'' at the left.
''Auto'' at the right.
DESCRIPTION OF TRACTOR CONTROLS
48
HODP049
HODP050
HODP051
HODP052