Hengstler Tico 772 Instruction Manual page 79

Signals
ac
tive
o
n/off
Application
in
put/output:
Application –
Set
to
Betriebsanweisungen_772_080909 engl_überarbeitet.indd 79
4
General
description of the multifunction counter
During normal operation the relay is energized if the signal is active.
This behavior can also be inverted (also applicable to the transistor outputs).
Depending on the standard function, up to 11 (eleven) functions can be assigned to the
application input/output. Note, however, that only one of these functions can be
selected.
Further details are given in the Function Code section (5.4).
Programs the application input to act as a Set Input. The counter is set to Preset 0,
independently of the reset via input C or the keyboard.
This function is not available for tachometers.
49
06.07.2010 10:31:51