Hengstler Tico 772 Instruction Manual page 59

The factory default setting is designated with an asterix *.
3.8 Programming the
By simultaneously pressing the E + Up, E + Down or E + Shift key you can change to the Preset programming
mode:
Use the shift key in the programming mode to change a setting position. The selected position will start to
flash. Use the shift key again to move one position to the right. Then use the UP or Down key to increment or
decrement the position by 1.
Rule for the 6th position: The change from 9 to 0 or 0 to 9 is indicated by a changing prefix.
Use the E key to leave the programming mode and return to the display mode. Your entries will be saved.
On leaving the programming mode, the presets are tested for attainability and recalculated, if necessary,
because not all the values may be attained at a prescaler value of >1. The presetting is then rounded to the
next attainable value.
Betriebsanweisungen_772_080909 engl_überarbeitet.indd 59
3
Setup and
Preset
37
Operation
Values